Industrial refrigeration
Gree Unveils Factory-Matched Inverter Cold-Room Package with Hot-Gas Defrost
At the Ningbo exhibition on 18 November 2026, Gree presented an integrated cold-room unit that bundles variable-speed compression, hot-gas defrost, frosting-delay control, and remote monitoring into a single factory-matched package. The supplier discussed a short demonstration and savings estimates, but the published report does not establish a general annual saving or payback period.

Gree presented an integrated inverter cold-room unit at the Ningbo exhibition on 18 November 2026. The package is factory-matched to reduce on-site assembly and supports group control as well as operating-energy records.
What the package includes
The unit combines four functions in a single enclosure: variable-speed (inverter) compressor operation, hot-gas defrost, a control strategy intended to delay frosting, and remote monitoring. Because the components are matched at the factory, installers face less on-site assembly work than with separately specified parts.
Hot-gas defrost and its limits
Hot-gas defrost routes compressor discharge heat to the evaporator to melt accumulated frost. The supplier noted that the actual energy benefit of this method depends on the specific load, the rate of frost accumulation, the control logic in use, and the system against which savings are measured. Gree discussed a short cold-room demonstration and provided savings estimates in that context, but the published report does not establish a general annual saving or a payback period applicable across installations.
Designers evaluating the unit should compare matched duty conditions and measured energy consumption over representative operating cycles rather than relying on a single demonstration figure.
ORIGINAL SOURCE
制冷快报 ↗Visit the original source for additional details.


