Industrial refrigeration
MostBT publishes multi-factor approach to preventing corrosion under cold-pipe insulation
MostBT has outlined a set of recommendations for preventing corrosion under insulation in chilled-water, coolant, and refrigerant pipework, covering insulation sizing, vapour-resistant materials, and sealing at connection points. The company stresses that no single material guarantees protection and that real-world performance depends on pipe material, moisture exposure, chemical properties, and installation quality.

According to KHARN, MostBT has published a structured approach to preventing corrosion under insulation (CUI) in chilled-water, coolant, and refrigerant pipework. The recommendations address several factors simultaneously rather than relying on a single material choice.
Recommended measures
MostBT's guidance covers the following areas:
- Sizing insulation to match site-specific temperature and humidity conditions.
- Selecting vapour-resistant closed-cell insulation materials.
- Assessing water-soluble corrosive constituents that may be present in the environment.
- Sealing at valves, joints, flanges, and pipe supports to block moisture ingress.
For outdoor installations, the company adds protection against rain and ultraviolet exposure, along with periodic inspection for physical damage and trapped moisture.
Material choice is not a guarantee
MostBT promotes its PVC-free EPDM foam insulation, including the Aeroflex line, but the company explicitly notes that selecting a particular material alone does not guarantee corrosion prevention. Actual performance depends on the pipe material, the degree of moisture exposure, tested chemical properties of the insulation, and the quality of installation.
Data-centre cooling: dew point matters
In liquid-cooled data centres, MostBT points out that condensation risk is specifically associated with pipe sections operating below the surrounding-air dew point, not with every section of coolant pipework.
ORIGINAL SOURCE
Kharn ↗Visit the original source for additional details.


